Tienda | Forums | Blogs | ES |
 

The water level sensor (lung diaphragm) can be repaired.

Follow
This post was translated, if you want to see the original version click here
DREAM EXCELLENT TD 900 RPM WASHER. The water level sensor does not work, since it does not cut the water and the drum is raised. It only works when air is introduced by blowing, connecting a hose to the original inlet. I don't get the replacement to replace.


  • 1 month ago

    Avatar de Carlos Quiroga

    Hello, and it will not be the hose that goes to the pressure switch that is clogged or is the same with which you do the test.

  • 1 month ago

    Avatar de ELOKODELASKOLINAS

    This is the hose that is not clogged, nor is the pipette or reduction that comes out of the tank, nor the drain.

  • 1 month ago

    Avatar de Carlos Quiroga

    But when you blow cuts or you feel that it makes cutting noise, because they are two different things since the pressure switch can make the cutting sound and not cut because the plates can be dirty. You would have to measure if it makes contact when blowing on the terminals.

  • 1 month ago

    Avatar de ELOKODELASKOLINAS

    when blowing if it cuts the water and begins to carry out the wash cycle, while retaining the blown air, by sealing the hose. The issue is to check the duct many times and it is not blocked. or if you have any rest, I clean it and connect again and it has not been washed more than once

2 Proposed Solutions

Hello, if the load cuts when blowing means that the pressure switch works correctly, then check the lung where the hose connects in the lower area may be covered with soapy residues, greetings.
  • 1 month ago

    Avatar de ELOKODELASKOLINAS

    that is to say that it can be the peak where the manguerita enters.

SOLUTION ACCEPTED
I share the preceding answers. If the pressure switch works, the problem is in the hose. Either it is clogged or has air leaks (heading) somewhere. Review it calmly and you will find the solution.
  • 1 month ago

    Avatar de ELOKODELASKOLINAS

    and try to change the sleeve thinking of breakage or puncture, a single wash worked the pressure switch, cut the water and did the complete wash. In the next time, the same thing happened again, it does not cut the water, nor does it perform the washing, but it does overhang the drum.

  • 1 month ago

    Avatar de ELOKODELASKOLINAS

    THANK YOU ALL FOR YOUR VALUABLE COLLABORATION AND GUIDE TO SOLVE THE PROBLEM

  • 1 month ago

    Avatar de Carlos Quiroga

    And what was the solution?

  • 1 month ago

    Avatar de ELOKODELASKOLINAS

    cleaning of the entire drainage system and admission from the lung down (reservoir hose and water extraction (water pump included).